View source for Getting started with eForams

eForams has two separte windows, one with controls and one for visualisation. 
Control windows has four tabs with controls for:
* 3D model
* 2D model
* Morphospace of 3D model
* Morphospace of 2D model

==Parameters==
Each tab has area with controls for changing parameters. Description of all the parametres you can find in [[MODELS]] section.

Additional subarea contains series of controls for so called fuzzines range. The model deals with parameters in two different manners:
* Each of the parameters is set up to the fixed value and does not change during the simulation
* At each simulation step we can choose the value of parameter randomly

Controls for fuzziness range allow us to decide how random the parameters are. Using this control we decide about the range from which the value of parameters are selected rondomly. Setting the controls to the left side we can reduce the range to single fixed value. Moving the controls we make the range wider what is marked around the controls.

==Simulation== 
We can control the simulation changing the number of chambers. The "Generate" button refresh run the simulation, however by moving the slider we run the simulation too.

==Morphospace==

==Drawing controls==

==Saving results==